This model consists of a box for storing/organizing pokemon TCG card decks.
It is a simple remix of two other models:
https://www.thingiverse.com/thing:4254758
https://www.thingiverse.com/thing:5341093
Assembly instructions:
-Print everything (each file specifies in its name the quantity and color to use, and beware that the file "ring" has two versions to select).
-Assemble the button with the collet, and add a spring (for example from a pen), and then assemble it with the ring and the top part of the ring which should be glued together allowing the button to operate correctly. If you find a gap at the junction between the two parts of the ring, you can fill it with black filament using a 3d pen.
-Glue the ring to the bottom part.
-Join the lid and the bottom part by means of the hinges (in my case I used a 2mm iron rod, and I bent its ends so that it does not come off).
-Attach and glue the latch in the hole of the lid, check first that it allows to open and close the box correctly.
-The internal organizer is not necessary to glue it since the same weight of the mallets keeps it in position, but if you feel that it is not firm then you can glue it.
That's all, I hope it helps and do not hesitate to remix if you feel that something is not quite right.
| 1x_box_bottom_-_white.stl | 931.8KB | |
| 1x_box_lid_-_red.stl | 1.5MB | |
| 1x_button_-_white.stl | 224.8KB | |
| 1x_button_collet_-_white.stl | 161.6KB | |
| 1x_organizer_-_red.stl | 104.0KB | |
| 1x_ring_top_part_-_black.stl | 33.0KB | |
| 1x_ring_without_anchor_disk_-_black.stl | 535.6KB | |
| 1x_ring_with_anchor_disk_-_black.stl | 608.3KB | |
| 1x_top_latch_-_red.stl | 16.5KB | |
| 4x_rubber_feet.stl | 684.0B | |
| 6x_divider_-_red.stl | 139.8KB |
