Want to clip your Pokeball Plus to your hip By way of pants or belt? Here you Go!
Designed to use the wrist strap to hold the shell closed.
The gap between shells is so the Pokeball does not spin while in use, No need to get the
strap super tight and strain it.
Leave the finger ring below it as pictured.
Printed in .13 res using 10% Gyroid infill.
I used Line supports at 2mm only on the Shell, nothing else needs it.
Lines made removing pillar hole support much easier.
Just mirror the shell for both left and right sides.
To assemble first lightly scratch inside the Caps and the edges of the pillars so glue
can get that grip it loves.
Slide each shell onto the Backplate.
Add a small amount of your favorite glue into each Cap and snap them onto the pillars.
Use a piece of filament to connect the hinged clip to the back.
I have added a second backplate for those who wish to add a metal clip DIY style.
| PokePlus-Back-Add-Clip.STL |
| PokePlus-Back.STL |
| PokePlus-Caps.STL |
| PokePlus-Hinge.STL |
| PokePlus-Shell.STL |
