This is based off a design linked by Brian Zhang in 3D Printing group on Facebook.
Original found here https://www.tinkercad.com/things/6DvV82FRTWW
Discussed posting with Original file creator.
I wanted less parts to print and more cartridge slots than originally provided.
Currently printing my first attempt though only major difference in OG and mine is the cartridge holder which I will have to test out.
Original files start with OG.
Update: Ran out of filament at 80% completion. Print did not stop. I will have to attempt again.
Comment with any issues so I can revisit them if I missed it.
Update #2: Added V2 of the still untried 12 cartridge insert removing the bottom where support was needed.
Update #3: 12 cart insert does not work. Made the slots deeper and pull all of them closer to center. Cart holder V3 up. Update #3.1 fixed minor inconsistency with cart slot depth.
Update #4: Starting from scratch. There were things I wanted to alter that were too far into the groupings to easily change on the existing objects.
| OG_PokeBall_Clasp_Long.stl | 60.4KB | |
| OG_PokeBall_Clasp_Short.stl | 60.2KB | |
| OG_Pokeball_Display_Base.stl | 72.0KB | |
| OG_PokeBall_Hinge.stl | 23.5KB | |
| OG_Pokeball_Switch_Cartridge_Insert_7.stl | 107.3KB | |
| Pokeball_Bottom_Combined.stl | 732.0KB | |
| PokeBall_Cartridge_Insert_12_V3.1.stl | 163.2KB | |
| PokeBall_Top_Combined.stl | 926.4KB |
