I call it the "Ash" tray (see what I did there?). I mean yeah, the dude is 10 years old, but he's trapped in this age for couple of decades now - I'm sure he's a smoker.
This design was inspired (but not remixed) by this planter: https://www.thingiverse.com/thing:2239205
Notes:
You should enable supports for the lid printing (90 degree angles only). If you are printing with a glass bed, you can probably print without supports placing the lid upside down. I don't own a glass bed, so I printed with supports.
Every other part doesn't require support.
The button is a small part, so in order for it to look and feel better, I printed it with 100% infill (you can drop this value depending on your printer).
20% infill is more than enough for every other part.
When printing the middle part, I found that it'll look better if you align the button hole on the Y axis - this will eliminate the ghosting.
| Ash_Bottom.stl | 23.7KB | |
| Ash_Button.stl | 38.2KB | |
| Ash_Lid.stl | 24.7KB | |
| Ash_Middle.stl | 12.2KB | |
| Ash_Top.stl | 24.7KB | |
| Poke-AshTray.f3d | 608.3KB |
