Pokeball 3D Printer Model
The file 'Pokeball 3D Printer Model' is (stl) file type, size is 420.0KB.
The file 'Pokeball 3D Printer Model' is (stl) file type, size is 420.0KB.
This project is active on my Printables page. For additional Pokeball variants and project updates, check out: https://www.printables.com/model/687259-pokeball
My take on the classic design, with a print-in-place hinge and magnet lock. Interior diameter is 2.5" (63.5mm).
Misc. Info:
The print-in-place ring mechanism has two versions with different tolerances. Make sure your elephants foot compensation is set properly to prevent the hinge from seizing.
The loose version has a minimum gap size of 0.3mm, and should work with most printers, and the tight version has a minimum gap size of 0.2mm, and should only be printed if you are confident with your printer's capabilities.
The magnets I used measure 6mm x 1.75mm (6x2 nominal). I got them from amazon: https://www.amazon.com/gp/product/B07KJ9H31P
Printable alignment pins are included, but you can use machined pins too
| Button_Inner_23.stl | 81.7KB | |
| Button_Outer_23.stl | 65.2KB | |
| Lid_23.stl | 491.3KB | |
| Pin_4x4x6mm.stl | 70.4KB | |
| Pin_4x4x8mm.stl | 70.4KB | |
| Rings_23_0.2.stl | 272.2KB | |
| Rings_23_0.3.stl | 278.0KB |
