Pokémon Dusk Ball – Fully Functional With Button And Hinge 3D Printer Model
The file 'Pokémon Dusk Ball – Fully Functional With Button And Hinge 3D Printer Model' is (stl) file type, size is 5.1 MB.
The file 'Pokémon Dusk Ball – Fully Functional With Button And Hinge 3D Printer Model' is (stl) file type, size is 5.1 MB.
I couldn't find a decent dusk ball model, so took matters into my own hands.
this model is almost identical to the pokéball model by MrFozzie,but with a shell specific to the dusk ball. the instructions for that model all apply here. when printing and adding the shell pieces, make sure to put all of them in their proper place. While in theory it shouldn't matter which goes where, designing the shell pieces was not an exact science, so the pieces might only fit flush if put in their exact place.
Print settings:
printed at a 0.15mm layer height on Bambu lab Carbon X1
3 perimeters
10% infill
all parts fill benefit from supports, and shell pieces need to be printed with 2 raft layers
| 3mm_Hinge_Pin.STL |
| Button.STL |
| dusk_ball_bottom.stl |
| dusk_ball_top.stl |
| green_back_bottom.stl |
| green_back_top.stl |
| green_bottom.stl |
| green_front_bottom.stl |
| green_front_top.stl |
| green_left_bottom.stl |
| green_left_top.stl |
| green_right_bottom.stl |
| green_right_top.stl |
| green_top.stl |
| Inner_Shell_Bottom_3mm.stl |
| Inner_Shell_Top_3mm.stl |
| Outer_Button_Smaller.STL |
| Stand_.STL |
