Poké Ball Plus Clip W/ Bolt 3D Printer Model
The file 'Poké Ball Plus Clip W/ Bolt 3D Printer Model' is (stl) file type, size is 234.82 KB.
The file 'Poké Ball Plus Clip W/ Bolt 3D Printer Model' is (stl) file type, size is 234.82 KB.
Designed a clip for the Poké Ball™ Plus controller by Nintendo. The clip attaches to the outside of the controller while the bolt fastens into the threads on the top of the clip to depress the button, automatically allowing you to spin stops and catch Pokémon in Pokémon GO. The ring loop on the string attached to the back of the device can be attached to the top of the bolt for straight vertical hanging. Additionally, the clip allows the controller to stand upright without rolling away. Happy #PokemonGOFest2021!
Printing:
Clip - 0.12-0.15mm resolution, 20% infill
Bolt - 0.12-0.15mm resolution, 20% infill
Ran a knife on the inside of the threads on the clip after printing to shave off a bit of excess material left by supports. Highly recommended, as the clip and bolt are tight fit. Be careful putting the clip on as to not scratch the controller.
| bolt.stl |
| clip.stl |
