Poké Ball Planter (+MultiMaterial) 3D Printer Model
The file 'Poké Ball Planter (+MultiMaterial) 3D Printer Model' is (stl) file type, size is 909.49 KB.
The file 'Poké Ball Planter (+MultiMaterial) 3D Printer Model' is (stl) file type, size is 909.49 KB.
The bottom is chamfered before being filleted to allow for a pretty print without needing supports. There are also no holes in this planter. The middle (black) piece has no clearance, so make sure your extruder is calibrated well. This is to be sure there is a snug fit of the parts so they won't fall apart before you get soil in there. You can slightly scale down this piece if you can't get it to fit together. I'd still suggest gluing the pieces together or only lifting your plant by the bottom to avoid making a mess.
The multi material version does not have an inset black ring, but is instead flush with the red and white surfaces. The button should be printed separately and glued into place.
Both models have a slight depression in the center where the button should fit. It won't snap into place, but will help position it for gluing.
These models were designed from scratch after watching the How-To video for the model this is based on.
| 100mm_MultiMaterial_Pokeball_Planter_v7_Bottom.stl |
| 100mm_MultiMaterial_Pokeball_Planter_v7_Button.stl |
| 100mm_MultiMaterial_Pokeball_Planter_v7_Middle.stl |
| 100mm_MultiMaterial_Pokeball_Planter_v7_Top.stl |
| 100mm_Pokeball_Planter_v3_Bottom.stl |
| 100mm_Pokeball_Planter_v3_Button.stl |
| 100mm_Pokeball_Planter_v3_Middle.stl |
| 100mm_Pokeball_Planter_v3_Top.stl |
| 125mm_MultiMaterial_Pokeball_Planter_v7_Bottom.stl |
| 125mm_MultiMaterial_Pokeball_Planter_v7_Button.stl |
| 125mm_MultiMaterial_Pokeball_Planter_v7_Middle.stl |
| 125mm_MultiMaterial_Pokeball_Planter_v7_Top.stl |
| 125mm_Pokeball_Planter_v2_Bottom.stl |
| 125mm_Pokeball_Planter_v2_Button.stl |
| 125mm_Pokeball_Planter_v2_Middle.stl |
| 125mm_Pokeball_Planter_v2_Top.stl |
