This is a wall mount for the original ps2 that is made to be as discreet as possible. I was unsatisfied by the models I could find as I would like the mount itself to be seen as little as possible. After all, you want to see the painting, not the hook it hangs on.

At first glance the shape of the bottom piece may seem odd, but this is all in the name of stealth. You see the protruding part on the top right is a keying mechanism to allow the mount to sit within the footprint of the ps2 without it risking sliding off. The underside of the ps2 is mostly flat with nothing to grab onto, save for the small section of "grill" on the front side next to the controller ports.

This needs to be printed with supports, but choose the option "only touching build plate" if you are using cura, or else it might do something stupid like put supports in the screw holes.

As you can see in the picture of the top part I have it mounted with some spacers, this is because I apparently cant measure properly and made the initial model too short. But the model I've uploaded should be correct since I added 5mm to it.

Edit 20240302: the new top mount does indeed fit perfectly as can be seen on the second picture.