I have a Playseat Trophy for my Sim Racing Rig. To get my monitor to swing over from my desk at a good height I had to raise the rig and I came up with this.
The front ones sit where the chair hits the ground. Watch out for correct orientation, the angle of the tubing at that point isn't symmetric. They are modeled with this.
I used these with Bed Risers I got from home depot to raise it about 7" Total.
https://www.homedepot.com/p/Everbilt-6-in-Black-Bed-Risers-4-Pack-4902244EV/306757968
The base is 2.6" x 2.6"
The small hole slot was added to attach a hose clamp, it was not needed, they snapped on perfectly.
x2 of Rear
x1 of Left Front
x1 of Right Front
I have also attached the Fusion 360 File and Step File for the design. Hopefully that will help someone else with there design.
You could try to extended the pieces I have here to your required height, but I'm not sure if it would hold the weight. The bed risers were rated for 300lbs each.
| Front_Left.stl | 407.2KB | |
| Front_Right.stl | 388.7KB | |
| Playseat_Trophy_Risers.f3d | 92.4KB | |
| Playseat_Trophy_Risers.step | 302.1KB | |
| Rear_Support.stl | 74.2KB |
