Drying out my Platypus after a hike usually takes days, so I decided to make use of a few things and a 3d model to build this fan that cuts the dry time down to 90 minutes.
Other things needed:
I used the included screws to attach the print to the fan with the airflow going INTO the bag. I cut off the case fan's connector and then stripped the wires (black is negative, red is positive) to insert into the adapter and secure.
80mm_platypus_dryer.stl | 42.8KB | |
bottom_80mm_platypus_dryer.stl | 28.3KB | |
top_80mm_platypus_dryer.stl | 24.4KB |