I designed a new filament/spool holder for my IKEA LACK table enclosure.
The problem was, that when you use a filament guide within the table-top, then the filament might get stuck if it is not straight above the guide/hole.
So i decided to design a spool holder, that will move where the filament is pulling it ;-)
To build this you will need:
You can also just let it stand on the base plate instead of mounting it to a linear guide!
Changelog:
2018-01-05:
| 01_Roll_130mm.stl | 42.3KB | |
| 01_Roll_130mm_concave.STL | 539.8KB | |
| 02_ground_plate.stl | 482.6KB | |
| 03_side_plate_100mm.stl | 147.5KB |
