What to print:
You need the "Ring" three times. Every other part is only needed once.
How to assemble:
Glue 2 of the 3 body-rings onto the "handle-holder" part.
The remaining ring is glued onto the "plunger-cap"
Screw the handle-holder and the fluid onto the body. Both go in thread first.
Put the Body-Ring onto the fluid.
Screw the needleside-cap and the needle onto the fluid.
Pull the plungerside-cap over the plunger, thread first.
Screw the plunger into the plunger-cap
Et voilÃ
You could print the Body and Body-Ring as one object, if you used support material.
| Body-Ring.stl | 38.8KB | |
| Body.stl | 258.5KB | |
| Fluid.stl | 234.9KB | |
| Handle-holder.stl | 295.4KB | |
| Needle.stl | 119.4KB | |
| needleside-cap.stl | 229.2KB | |
| plunger-cap.stl | 154.8KB | |
| Plunger.stl | 90.9KB | |
| plungerside-cap.stl | 153.2KB | |
| Ring.stl | 38.6KB | |
| Syringe.f3d | 438.7KB |
