Pitts S1/S2 3D Printer Model
The file 'Pitts S1/S2 3D Printer Model' is (stl) file type, size is 4.6MB.
The file 'Pitts S1/S2 3D Printer Model' is (stl) file type, size is 4.6MB.
All parts are detachable.
Use brim, support and different nozzles as needed on different parts. The landing gear is a bit tricky, but perfectly printable.
This print is not for newbies ;-)
Enjoy!
| Pitts_S1_Canopy.stl | 785.9KB | |
| Pitts_S1_Fuselage.stl | 5.6MB | |
| Pitts_S1_LandingGear_L.stl | 269.7KB | |
| Pitts_S1_LandingGear_R.stl | 269.7KB | |
| Pitts_S1_Propeller.stl | 71.4KB | |
| Pitts_S1_Propeller_Cone.stl | 1.1MB | |
| Pitts_S1_Propeller_Shaft.stl | 403.9KB | |
| Pitts_S1_Tail_Horizontal_L.stl | 173.8KB | |
| Pitts_S1_Tail_Horizontal_R.stl | 173.8KB | |
| Pitts_S1_Wheel.stl | 2.3MB | |
| Pitts_S1_Wing_Bottom_L.stl | 269.9KB | |
| Pitts_S1_Wing_Bottom_R.stl | 271.7KB | |
| Pitts_S1_Wing_Support_Bottom_L.stl | 119.4KB | |
| Pitts_S1_Wing_Support_Bottom_R.stl | 119.4KB | |
| Pitts_S1_Wing_Support_Top_L.stl | 53.8KB | |
| Pitts_S1_Wing_Support_Top_R.stl | 53.8KB | |
| Pitts_S1_Wing_Top.stl | 747.1KB |
