Take pitchcar to even greater heights! (same height as extension 4)
bottom ramp is the same as used in my banked turn set
https://www.thingiverse.com/thing:5499342
the ramp itself is a very specific length to reach the same height as the official extension 4 set. (albeit over a different length) I made it an arrow pattern so I would clearly see which piece it was.
Top part (Pitchcar expansion 4top) sits on (Pitchcar expansion 4 support). can put this support upside down to support further track pieces and secure it with bullclips if needed.
2 level support file was added as it works with track at both this height and the height for my flat ramp set. https://www.thingiverse.com/thing:5854435
can even put both levels in the same support, but not really reccomended as it's hard to get your hands in position to flick.
| 2_level_support.stl | 27.3KB | |
| arrow_track.stl | 2.1MB | |
| banked_corner_ramp.stl | 234.0KB | |
| Pitchcar_expansion_4_support.stl | 6.2KB | |
| Pitchcar_expansion_4_top.stl | 258.5KB |
