This is a collection of pipe fittings that may be used to create realistic pipework. The fittings have a 5mm outside diameter and may be scaled to suit your requirements. If required, you may mirror the Sewer Elbow and Sewer Tee (all other models are symmetrical). For my 1-in-20 models, I printed these at 200% scale.
See also: https://www.thingiverse.com/thing:5356308
Design Parameters:
You could use them as downpipes, drains and sewer pipes. You may use the pipes to hide low voltage wiring in your diorama or tabletop game. At a larger scale you could use these for character access passages.
Suggested paint finishes are: terracotta colour for clay pipes, concrete colour for drains, wall colour for downpipes.
Print using either a filament or resin printer (preferred). When generating supports in your slicer, raise the items a few millimetres above the print surface. Use a function similar to “Touch Platform Only” or “Platform” to avoid generating supports inside the fittings.
If using a resin printer, print pipes so that they are vertical. You should be able to fit a few on the build platform. This should also give better print quality.
2024-01-10 - added Corner Connector
| Clamp_Bolt.stl | 103.8KB | |
| Clamp_Hole.stl | 100.5KB | |
| Corner_Connector.stl | 978.0KB | |
| Cross.stl | 259.5KB | |
| Drain.stl | 1.2MB | |
| Drain_Elbow_45deg.stl | 493.6KB | |
| Drain_Grate.stl | 39.9KB | |
| Drain_with_Grate.stl | 1.2MB | |
| Elbow_45deg.stl | 520.0KB | |
| Elbow_90deg.stl | 916.9KB | |
| Joiner.stl | 147.1KB | |
| P-Trap.stl | 1.7MB | |
| S-Bend.stl | 2.2MB | |
| Sewer_Elbow.stl | 1.4MB | |
| Sewer_Tee.stl | 1.0MB | |
| Straight_100mm.stl | 35.2KB | |
| Straight_150mm.stl | 35.2KB | |
| Straight_200mm.stl | 35.2KB | |
| Straight_250mm.stl | 35.2KB | |
| Straight_50mm.stl | 35.2KB | |
| Straight_75mm.stl | 35.2KB | |
| Tee_45deg.stl | 179.8KB | |
| Tee_90deg.stl | 182.7KB |
