Pimoroni Pirate Radio Speaker Mod 3D Printer Model
The file 'Pimoroni Pirate Radio Speaker Mod 3D Printer Model' is (scad,stl) file type, size is 51.6KB.
The file 'Pimoroni Pirate Radio Speaker Mod 3D Printer Model' is (scad,stl) file type, size is 51.6KB.
This is my first design - a little box to replace the back of the Pimoroni Pirate Radio: https://shop.pimoroni.com/products/pirate-radio-pi-zero-w-project-kit
It is still far from HiFi, but (in my opinion) the radio sounds at least a bit better with this.
Print:
Print upside down (speaker hole located on the heat bed)
Assembly:
Update 2017-08-19: Increased size of screw/nut holes
Update 2017-08-21: Moved nut hole further to the front (otherwise the screws are too short...)
| radio.scad | 5.3KB | |
| radio.stl | 499.5KB |
