Pimoroni NVMe Base Raspberry Pi 5 Case For Astrophotography 3D Printer Model
The file 'Pimoroni NVMe Base Raspberry Pi 5 Case For Astrophotography 3D Printer Model' is (stl) file type, size is 140.4KB.
The file 'Pimoroni NVMe Base Raspberry Pi 5 Case For Astrophotography 3D Printer Model' is (stl) file type, size is 140.4KB.
This is a case for Raspberry Pi 5 with Pimoroni NVMe Base.
It is a bit different from my other case that supports the NVMe base because it supports a 12V-5V step-down power converter Amazon-Link. I used some hot-glue to keep the converter in place.
The converter then supplies the RPi with power via the GPIO-Pins. Both, original USB and 12V power can be used now.
The bottom part also has two holes for M3 threaded inserts. So you can attach the case to a telescope rail or attach a finder-shoe to it. Please make sure the screws do not touch the NVMe base.
It fits a RPi5 with the official fan and RTC battery. Should also fit with common HATs, but not tested.
Use the printable spacers instead of the spacers coming with the NVMe base since they are a little smaller. Use the screws from the NVMe base to hold the case together.
SD-card slot and power button are accessible but it's all a bit tight.
| RPi5_Case_bottom_big.stl | 130.4KB | |
| RPi5_Case_spacer.stl | 11.8KB | |
| RPi5_Case_top_big.stl | 435.7KB |
