Introducing the Pill Packer 100x! Fill 100 "00" (750mg) and/or "0" (500mg) vegetable capsules at a time using whatever powder supplement you desire.

There are only three functioning parts: the pill holder, packer, and platform

Place the holder on top of the platform making sure is slides onto the cylinder and latches onto the notch. Then place a rubber band over the end of the notched side, if you plan on moving it around or packing them fairly hard. Place the capsules open end opposite the platform into the desired amount of slots then poor your powdered material over the capsules. Take a postcard, credit card or simply a piece of paper and wipe the excess off the top making sure to fill each hole as you move the card around. Take your packer line it up with each pill and press down firmly until the packer starts to sink down into the holes, pack to desired depth using small taps of the hand to press the powder down firmly.

Taking the pills out is simple, remove the rubber band and undo the bottom over a large container so your capsules don't fly everywhere. Then using the packer push the rest of the pills that remain out and apply the caps to each capsule.

NOTE: The picture for the pill holder may show problems on the top side such as capsule holes being blocked off however these are NOT on the actual model when printed and this is only a program error within STL viewing programs.