PiggyBank 3D Printer Model
The file 'PiggyBank 3D Printer Model' is (stl) file type, size is 4.0MB.
The file 'PiggyBank 3D Printer Model' is (stl) file type, size is 4.0MB.
Piggy and Boar cubes for your savings
More PiggyBanks:
Piggy Bank Vault (wich this model was based on):
100x100x109mm
No supports needed
No glue needed for assembly
Eyes and a smile will snap together with base model
Original models are with a lid (printed separately) but there is a version without it too (you will need to break a piggybank to get the money then)
If you don't have a good cooling on your printer you can print a base and a face separately - use PARTS files then
Face should snap in to base model but those models were not print tested. In the worst case you will need to use a glue
| PiggyBANK-BOAR-closed.stl | 1.3MB | |
| PiggyBANK-BOAR.stl | 1.3MB | |
| PiggyBANK-BOAR_Fangs.stl | 224.6KB | |
| PiggyBANK-BOAR_PARTS-face.stl | 795.8KB | |
| PiggyBANK-closed.stl | 1.2MB | |
| PiggyBANK.stl | 1.2MB | |
| PiggyBANK_Eye-inner_black_x2.stl | 49.7KB | |
| PiggyBANK_Eye-outer_white_x2.stl | 118.6KB | |
| PiggyBANK_Lid.stl | 33.7KB | |
| PiggyBANK_PARTS-Base-closed.stl | 671.8KB | |
| PiggyBANK_PARTS-Base.stl | 668.0KB | |
| PiggyBANK_PARTS-face.stl | 714.1KB | |
| PiggyBANK_Smile.stl | 42.3KB |
