UPDATED 8-7-17
Caution: according to Simplify3d it will take over 20 hours to print on a Prusa in Fast Mode at 15% infill. I am going to print one when I have time with a brim.
Here are two versions of a piggy bank. One has an opening on the bottom and a plug and should be printed with supports. The other is a one piece bank that should be printed WITHOUT supports. It is hollow and roughly 5"x5"x5". The slot at the top should handle up to a quarter. Coins can be shaken out The one piece version intentionally does not have a way to open it other than cutting it open. The two piece version has a friction fit plug that should be glued in place with some flexible glue that you can remove to be able to open it.
I have uploaded two versions fo the file, both are meant to be printed with the safe positioned with its back on the print bed, door facing up. One requires supports the other does not. See the Misc. Notes section.
| 17_bank_body_with_bottom_hole.stl | 807.5KB | |
| 17_bottom_plug.stl | 21.2KB | |
| 17_one_piece_bank_no_supports.stl | 798.1KB |
