PiFinder Center Pivot Unibody 3D Printer Model
The file 'PiFinder Center Pivot Unibody 3D Printer Model' is (stl) file type, size is 255.0KB.
The file 'PiFinder Center Pivot Unibody 3D Printer Model' is (stl) file type, size is 255.0KB.
This was a substantial project based upon the exceptional PiFinder (https://www.pifinder.io) in that every component, with exception for the original Raspberry Pi Camera Shroud, was redesigned from the ground up.
This work centers around the Version 2 PiFinder and eliminates the need to print up separate parts in order to configure the PiFinder for either the Left Hand, Right Hand or the Flat configurations and replaces all of that with one single design.
The cameras position (orientation) is constrained by indexing to any of the three positions but by simply printing the two parts (that are marked with an "Indexed" name will allow the camera to be oriented in an unrestricted fashion.
| V2r_Knob_Center_PiFinder.stl | 330.8KB | |
| V2_Bottom_Plate_Center_PiFinder.stl | 42.3KB | |
| V2_Camera_Cover_Center_PiFinder.stl | 45.6KB | |
| V2_Camera_Mtg_Plate_Center_PiFinder.stl | 88.9KB | |
| V2_Camera_Pivot_Center_PiFinder.stl | 56.3KB | |
| V2_GPS_Mount_Center_PiFinder.stl | 35.0KB | |
| V2_Indexed_Bottom_Plate_Center_PiFinder.stl | 52.9KB | |
| V2_Indexed_Camera_Pivot_Center_PiFinder.stl | 67.0KB | |
| V2_Shroud_Bezel_Vents_Cmb_Center_PiFinder.stl | 208.3KB | |
| V2_Unibody_Center_PiFinder.stl | 191.5KB |
