Picture Frame Wire Shortener (Parameterized) 3D Printer Model
The file 'Picture Frame Wire Shortener (Parameterized) 3D Printer Model' is (scad,stl) file type, size is 7.8KB.
The file 'Picture Frame Wire Shortener (Parameterized) 3D Printer Model' is (scad,stl) file type, size is 7.8KB.
This is based on this idea for shortening a wire. The intent is that if you have a picture frame wire that's a little too long, you can wind it around this to take up some of the slack and shorten it. By using this, the picture will hang higher on the wall than it would have originally. This allows you to put your hook or nail in a little lower and then fine tune the height by adding or removing windings.
Included is the OpenSCAD source file, so you can modify this for your exact situation.
| Picture_Frame_Wire_Shortener.scad | 664.0B | |
| Picture_Frame_Wire_Shortener.stl | 38.9KB |
