Picatinny 3 slot 1-inch rail riser. Used for a small red dot optic or such device. PRINT STANDING ON END OR IT WILL NOT BE STRONG IN THE DIRECTION OF MOST STRESS.
Update: Picatinny 3 slot 1-inch rail rise supports #6 - 32 1" hardware. The nut and bolt holes are sized to accomodate. The rail hole (bottom) was scaled bigger by 1.02 to allow for tolerences.
How do I get this thing on and off my rail? If you have a picatinny rail that has something similar to a floating barrel, this will simply slide on and off into place, if there is no obstructed path.
Otherwise, you will have to snap this into place. I have only used PLA/wood material which has proved strong and flexible-ish enough to stand the streching of the rail. To snap on to the accepting rail, simply place one side of the riser onto the accepting rail and pull it over onto it. It should expand enough to snap into place. To remove, I have used a screwdriver (carefully so as not to scratch the accepting rail) to lift one edge of the riser off the accepting rail. It has simply popped off with a little pressure. Good luck!
| Picatinny_Rail_Baseline_Extruded_Slotted_Drilled_6_-_32_Hardware_v2.stl | 66.7KB | |
| Picatinny_Rail_Riser_3_Slot_1_Inch.stl | 52.6KB |
