Should print fine with supports, but my slicer had issues where it did not create supports for the top weaver rail, so i added a model with supports that you can cut away as needed. The 3 degree angle makes it perfect for paintball. Enjoy!
The screws used are standard metric M4 ones, but i think No.8-32 will fit too. The solidworks file is also there so you can alter the model to your needs.
Edit: The V2 solidworks file is the same one i created in solidworks 2013, but resaved on SW2016, since somebody had issues opening the old file in SW2018
Edit 2: I've added a 2 degree riser and a low model for both 2 and 3 degrees incline. Unfortunatly SW2016 made a mess out of my model so i used meshmixer to create the 2 degree and low models, and i only did the 3D model with support.
| Paintball_2_degree_angled_Picantinny_Sight_Riser_base_-_with_supports.STL | 79.2KB | |
| Paintball_2_degree_angled_Picantinny_Sight_Riser_base_LOW_MODEL_-_with_supports.STL | 79.2KB | |
| Paintball_3_degree_angled_Picantinny_Sight_Riser.SLDPRT | 436.0KB | |
| Paintball_3_degree_angled_Picantinny_Sight_Riser_base_-_no_supports.STL | 73.1KB | |
| Paintball_3_degree_angled_Picantinny_Sight_Riser_base_LOW_MODEL_-_with_supports.STL | 79.2KB | |
| Paintball_3_degree_angled_Picantinny_Sight_Riser_clamping_part_-_no_supports_needed.STL | 109.7KB | |
| Paintball_Picantinny_Sight_Riser_V2.SLDPRT | 224.7KB |
