its intended to be snap fit " no screws needed", prints in four parts top, bottom, front and pin cover.
The pin flap was/is intend to be hinged but it has such a snug fit I left it as is. The one down side to it because I rounded the sides access to the SD card is a tad problematic with ejecting it, its a little further into the case than I would have liked. but I left it that way thinking " how often will I need access to it.
| pi_case3_bottom.stl | 166.7KB | |
| pi_case3_flap.stl | 18.7KB | |
| pi_case3_Front.stl | 3.4KB | |
| pi_case3_top.stl | 115.1KB |
