This is a mount for the Raspberry Pi Camera Module 2 designed for the Voron Trident. It includes one mounting bracket and an optional cable guide. You can use two cable guides - one below the top extrusion and one on top of the lower extrusion. The camera fits into the mount very tightly to prevent movement caused by vibration. Depending on your printer's extrusion, you might need to use a needle file to open up the channel a bit where the camera slides in. The original FreeCAD design file is included for your remixing enjoyment. This is intended to be mounted on the left top extrusion as close to the front of the printer as possible. The ribbon cable can be routed inside along the left side panel. It can slide between the top extrusion and the panel and then under the bottom panel. Included cable guides will keep the ribbon cable in place. Setting the camera resolution to 3280x2464 enables you to see most of the print bed from this angle (at least on my 300x300).