Edit 31.05.2020
Acc. to request in comments added:
V2 - cord slot on the other side than original
V3 - cord slot under whole width of stand
I was looking for some proper stand for my new OneBlade. Originally I was inspired by this thing by xenotrim: https://www.thingiverse.com/thing:2986584
Thank you xenotrim! https://www.thingiverse.com/xenotrim/about
It was not exactly tha one I was looking for so I designed the new Thing, by Fusion 360.
I designed the side slots for trim adapters slanted by 10 degrees in order to keep them in place as the slots are designed with a clearance.
I added the specific side slots for 2pcs of spare razor blades. There is enough space to put there razor blades even with the attachments on it.
Main slot for the razor is divided in order to attach the charging cord easily and properly fix the charger in prepared slot for the connector. Just push slightly the connector towards the eliptical slot and it is firmly fixed.
On the top only added two slots for additional equipments.
Hope you like this and find it useful.
If you would give it a shot, please share your makes. I would be curious for your results...:-)
I added two versions of stand, 50mm and 45mm width of side slots.
| oneblade_stand_45mm_side_slots.stl | 1.4MB | |
| oneblade_stand_50mm_side_slots.stl | 1.4MB | |
| V2_cord_Oneblade_stand_45mm_side_slots.stl | 1.2MB | |
| V2_cord_Oneblade_stand_50mm_side_slots.stl | 1.2MB | |
| V3_cord_Oneblade_stand_45mm_side_slots.stl | 1.3MB | |
| V3_cord_Oneblade_stand_50mm_side_slots.stl | 1.3MB |
