Since I've bought this beard trimmer I've been frustrated that there was no stand for it (unlike other Norelco products), so I took it upon my self to fix that.
This stand works with the Philips Norelco Series 5000 Beard Trimmer with and without the charger.
Most of the pieces for the stand are printed in two pieces just to make printing sane. Once printed, simply screw the halves together. If you want to use the charger with the stand, simply unscrew the stand a bit, slip the cable in between the two halves and finish tightening. The dowel end and end stops need to be printed twice, but the files are named to indicate this. I eventually want to redo the end stops, but I'll save that for a while. For now, they should be a snug fit or require a drop of super glue.
Other printing notes: I printed everything at ~5% infill, never used any support, but did use a brim to print the dowel vertically
| 2x_Dowel_End.stl | 79.8KB | |
| 2x_End_Stop.stl | 190.5KB | |
| Base_Left.stl | 106.9KB | |
| Base_Right.stl | 106.1KB | |
| Dowel.stl | 145.6KB | |
| Stand_Left.stl | 300.4KB | |
| Stand_Right.stl | 304.7KB | |
| Support_Left.stl | 355.8KB | |
| Support_Right.stl | 356.1KB |
