This still a work in progress, as the pins that join the sides together became slightly mis-aligned after flipping one of the sides to correct map orientation. It's an easy fix, so I went ahead an published. Will upload the corrected version in the near future. Note that the holes on the female side for the pins are 5mm, while the pins themselves are 4mm. I did this to aid in assembly. Glue together if friction fitting is too loose.
| phil_napkin_holder_complete_NEEDS_FIXING.stl | 1.2MB | |
| phil_napkin_holder_female.stl | 185.0KB | |
| phil_napkin_holder_male.stl | 278.0KB |
