The roof rails for a Peugeot 206 use adapters that screw into the frame of the car under the door seals. I found these annoying to take off but leaving the adapters on creates whistling noises.
This cover is designed to reduce the whistling noise.
Uses 4 M6 Nuts and 4 M6x12mm bolts. The M6 nut needs to be put into place while printing. I paused the print at layer 37 and then resumed it to cover the nut. Locking nuts are a bit too tall for the current design (v2). The screw needs 1nm of Torque.
V2: Increased roof rail hole insert size, Increased curvature of corner on back plate, Increased length of back plate, Decreased length of chamfered edge
| Back.ipt | 333.0KB | |
| Back_V2.stl | 40.0KB | |
| Front.ipt | 290.0KB | |
| Front_V2.1.stl | 62.2KB |
