Remixed the PetsFang v2 to fit the Ender 3 max neo. It is not the prettiest thing, but it works. I used the Ender 2 v2 baseplate, and modified it to fit the Neo's factory hotend. Then had to modify the Fangs mounting points to fit the Baseplate. I did not change anything with the actual fan ducts.

This is modified to fit the Sprite SE extruder. Had to lose the wire guide mounts in the back.
I used the PetsFang ALL_BLT_LEFT_x-48_Y-10_3.29 for the CR touch mount. I cut the middle section out to fit the connector/wires. I bolted only the Left side of the CR touch to the mount. It is a bit bulky and you lose the first 7mm of the bedplate Y axis because of CR touch. I am too lazy to make it work as a right mount CR touch as I dont ever use the full bedplate.

I also included the blender (V4.2) file in case anyone wants to make further improvements.

Offsets are
X:-62
Y:-13

X- stepper motor
End stop position is 7.0.
Min position is 7.0
max position is 312

Hardware Needed:
Fan Mount Hardware:
4 - 8-32 x 1 Inch machine screws
4- 8-32 nuts

Fangs to Baseplate Hardware:
3 - M4-.7 x 12 machine screws or #8 x 1/2" machine Pan head screws

BasePlate to Ganty Hardware
Factory Mounting screw for plastic cover

CR Touch mount to baseplate:
1 - M3-.5 X 10 Screw
1- M3-.5 Nut

HotEnd fan to Baseplate
2 - #4x3/4 screws