Tried printing a few quad-blasters, but decided to design my own so they print nicer.
print/paint in the colours as per the file names - print in the orientation they are in
just slice and print.
THERE ARE 2 “BLACK 1& 2 & 3” PIECES -
BLACK 1 & 2 & 3 - FITS ON MK3 BED
BLACK 1 & 2 & 3 SPLIT - FOR SMALLER BEDS
YOU ONLY NEED ONE OR THE OTHER
black 2 & 3 look nicer printed at 0.15 and variable layer height on the very top as low as poss
black 5 are little screw heads - need a brim and get stuck to the dimples in the part in black 1
8 pegs to help with aligning when gluing.
use your favourite glue
(unless your favourite glue is pva, dont use that, its rubbish for this, use superglue instead)
stick your red leather jacket on, don your walkman and vibe to some old tunes while snogging some green chick.
Added a whole print in one piece model for some stroppy prat on reddit. wouldnt suggest printing it, itll look terrible
| black-1.stl | 119.2MB | |
| black-2.stl | 6.1MB | |
| black-3.stl | 3.0MB | |
| black-4.stl | 12.0MB | |
| black-5-use-brim.stl | 3.0MB | |
| black_1_-_SPLIT_FOR_SMALL_BEDS_1.stl | 107.2MB | |
| black_1_-_SPLIT_FOR_SMALL_BEDS_2.stl | 12.0MB | |
| black_2__split.stl | 6.1MB | |
| black_3_-_split_for_small_beds.stl | 522.5KB | |
| gold-or-bronze.stl | 450.5KB | |
| pegs-any-colour-use-a-brim.stl | 17.3KB | |
| quad_blaster_WHOLE.stl | 30.8MB | |
| silver-or-grey.stl | 36.4MB | |
| silver.stl | 24.0MB |
