Pet Waterer 3D Printer Model
The file 'Pet Waterer 3D Printer Model' is (stl) file type, size is 334.8KB.
The file 'Pet Waterer 3D Printer Model' is (stl) file type, size is 334.8KB.
While I know auto pet waterers can be readily purchased, I decided to make my own. I got a plastic pan from a local farm store that was 4.5” deep and I had an old 1 gallon Coleman PolyLite personal cooler sitting around so I designed a stand to hold the personal cooler 3” from the bottom of the pan. I drilled a 5/8” hole in the lowest surface of the cooler’s lid and removed the built in straw and o-ring. I used food approved PETG filament. The two halves of the stand are connected using four #4 - ½” long stainless steel panhead screws. This setup makes keeping my dogs water bowl full a lot easier.
| Bottom_Ring_of_Watering_Stand.stl | 667.1KB | |
| Top_Ring_of_Watering_Stand.stl | 191.2KB |
