Pet Leash Hook 3D Printer Model
The file 'Pet Leash Hook 3D Printer Model' is (3mf,stl) file type, size is 3.9MB.
The file 'Pet Leash Hook 3D Printer Model' is (3mf,stl) file type, size is 3.9MB.
Needed somewhere to hang our dog's leash so I drew up this quick design. The paw print is a raised emboss. There are 2 versions...one without holes to hang with 3M command strips and one with holes for a #8 screw. There is also a file for caps to cover the # 8 screw. The elliptical hook printed fine without any supports.
if you print the screw caps, it works best if printed with a 0.4mm nozzle with 0.2mm layer height and the model is oriented on the print bed with the opening facing up. Note not all #8 screws are exactly the same. if the cap is too tight to push on with your finger, just heat the open side up for a few seconds with a lighter and it will slide right on and will snug up on the screw as it cools.
Enjoy!
| 8_Screw_Cap.3mf | 251.4KB | |
| 8_Screw_Cap.stl | 865.5KB | |
| Lease_Hook.stl | 2.5MB | |
| Leash_Hook-No_Holes.3mf | 769.5KB | |
| Leash_Hook-No_Holes.stl | 2.5MB | |
| Leash_Hook.3mf | 785.7KB |
