Pencilbox For Stabilo® Adventskalender 2020 3D Printer Model
The file 'Pencilbox For Stabilo® Adventskalender 2020 3D Printer Model' is (stl) file type, size is 1.2KB.
The file 'Pencilbox For Stabilo® Adventskalender 2020 3D Printer Model' is (stl) file type, size is 1.2KB.
This is a pencil organizing box for the german brand Stabilo® advent calender.
https://www.stabilo.com/de/stories/kreativer-adventskalender-2020/
The printed box fits inside the factory cardboard box and is split in two pieces for printers with smaller build volume.
This was printed with single layer walls (in Cura: Special modes - surface mode: Surface)
and for sucessful adhesion to the printing bed with a raft of +1mm.
If you want to keep the floor on the box - change the raft air gap to 0mm
otherwise it will seperate from the walls after finishing the print.
To reduce printing time and material - set the raft top layers to 0 and print just one base and one middle layer.
The Part A with the smaller grid is very sturdy, but part B with the longer walls is a bit flimsy and a bit of warping is likely to occur. should not matter too much inside of the cardboard box.
EDIT:
Raising the Parameter "Extrusion width" produces thicker walls and could help with the wobbly walls ;)
| Stabilo-box_A.stl | 4.2KB | |
| Stabilo-box_B.stl | 1.5KB |
