PAW PATROL TRACK VEHICLES – REMIX IV 3D Printer Model
The file 'PAW PATROL TRACK VEHICLES – REMIX IV 3D Printer Model' is (STL) file type, size is 5.3MB.
The file 'PAW PATROL TRACK VEHICLES – REMIX IV 3D Printer Model' is (STL) file type, size is 5.3MB.
My kids got out the tracks I made several years ago and asked for a vehicle that would fit the characters, but also fit on the tracks. I did the best I could. The vehicle is a little long for the slopes, but does fine on the standard tracks. The wheels are not as loose as my first try, but that vehicle was so wide it couldn't take the turns.
Ladder should be printed pointing upright. I printed it on a Bambu P1S and it came out fine, but the support at the bottom of the ladder stages stuck the two pieces together a little.
Car prints on its side. Both the car and the ladder need support. You need to keep the car support low like ten degree slope. If had it too high, it tried to put support inside the wheel wells where it would not be able to be removed.
Wings are a work in progress. I'm test printing them at the moment.
EDIT: 10/29/24 - I've made some modifications to the accessory car. The wheels didn't roll as well as the original. The V2.1 needed a little back and forth rolling on the carpet, but the wheels worked loose and are fine afterwards. I also uploaded the jetpack. I've printed several on my Bambu and they come out fairly nice. It's tricky getting the support out from under the wings, but it's worth it. I need to test print on my other printer to see if it will still come out.
| PP_Accessory_JetPack.STL | 2.6MB | |
| PP_Accessory_Ladder.STL | 1.9MB | |
| PP_TrackCar_V2.1.STL | 5.4MB | |
| PP_TrackCar_V2.STL | 4.9MB |
