These are passenger foot pegs for the Lectric XP 3.0 electric bike.

The foot pegs have the matching threading (M12 x 1.25mm) as the ebike's axle. Simply remove the rear wheel axle nuts on either side of the wheel then screw the foot peg on. Start threading the foot peg by hand and then there is 10mm socket slot on the other end of the peg to snug it up on the wheel. I basically tightened up until the 'blue' on the peg closest to the axle is just about touching the small silver screw about a cm to the upper right of the axle. Doesn't need to be 'gorilla' tight.

The foot pegs have rounded edges on the ends to hopefully avoid any lasting damage to your shins when you inevitably run into them. The peg is 9.5 cm long and 3.5 cm in diameter so the kick stand has no clearance issues etc. Be sure to save your axle nuts in a safe place if you want to revert back in the future.

SPECIAL NOTE :::: I didn't see foot pegs like these anywhere online and wanted to share with the Lectric ebike & 3D printing community, but please be very clear....you make this modification to your ebike AT YOUR OWN RISK!! I am not responsible for any injury or damages to you, your property or anyone else when using this model. I wouldn't go jumping up and down on these things at all, but as foot 'RESTS' for the Lectric XP 3.0 they are sturdy and appear to work well. See pics & gif above of a 115lb teenager on the back with no problems (max load capacity of bike is 150lbs FYI). I don't recommend standing on them with all your weight. Use them to just get your feet off the ground and out of the way of chain etc and put most of your weight on the seat. Please be safe & smart when using them!

That being said...I hope you enjoy and have fun riding.

CrizzledOne