My 1st experience with designing a piece from nothing. I needed some drawers for my electronic parts so I made this.
I will make a module for the spools of wires a bit later
I tested this with Wood filament, PTEG, PLA
ABS will warp too much for the shelf part, I can probably make more holes to relief the stress.
but I don't need it myself
New:
-New drawer with compatible hook for DinRail (http://www.thingiverse.com/thing:1581801)
-Label holder on separators and increased gap of separator by 0.1mm
Previous changes:
Notes:
-Scaling by 1000 may be needed, my units are mm in blender.
-New design for the drawers, pictures will be updated, this handles can fall off while printing.
| partdrawer3.2-Shelf.stl | 275.2KB | |
| partdrawer3.stl | 76.1KB |
