A funnel where the main parameters can be changed. You either get a special stand with it or not. When you want to use light things, like just a few tea leaves, pick the simple stand. The tripod stand should be much sturdier, but i haven’t printed one yet.
I wanted a funnel with a rather low throat ratio, if that is the term, to fill paper tea filters. The tea leaves always jam in the necks of supermarket funnels.
Set the sizes in the customizer. Then, when done, switch from “preview” to “render” and click “create thing”. You should get two STLS, one empty when you switch to the funnel only style.
| funnel-and-stand.scad | 13.0KB | |
| funnel_9_3_5.stl | 788.8KB | |
| funnel_tripod_11_1.5_7.stl | 826.3KB | |
| funnel_without_stand_5_1_3.stl | 1.8MB | |
| funnel_without_stand_9_1_6.stl | 1.8MB | |
| stand_9.stl | 30.9KB | |
| stand_tripod_11_1.5_7.stl | 66.9KB |
