Panel Lock 3D Printer Model
The file 'Panel Lock 3D Printer Model' is (stl) file type, size is 71.6KB.
The file 'Panel Lock 3D Printer Model' is (stl) file type, size is 71.6KB.
This lock is for a 18mm panel. If you want to use it on a 12mm panel use the parts with the "_short" extension in the name
Drill 20mm hole in panel
push part #1 through hole
push part #2 over part #1 and glue it to panel
push part #3 through
put part #4 on the end of part #1
glue part #5 as a stop on part #1
Some parts might be a tight fit (especially parts #2 and #5) to have a clamping effect, so a bit of pressure should do the trick to get them in place.
There's always room for improvement, so any suggestions are welcome
| 1.stl | 46.6KB | |
| 1_short.stl | 46.6KB | |
| 2.stl | 21.6KB | |
| 3.stl | 61.0KB | |
| 3_short.stl | 53.6KB | |
| 4.stl | 20.0KB | |
| 5.stl | 52.6KB |
