Printed with TPU using 50% infill without supports. Used with https://www.thingiverse.com/thing:5150262 to create a head tracking FPV mount for my 19mm camera. Mounts right in front of the receiver case/antenna. Note, it will block the antenna. I use a FrSky reciever now so don't use the stock antenna. I had to cut away much of the driver's side plastic to free it up for a good view but it works pretty well.
It is set up to mount a 9g servo on top (base of most pan tilt setups).
You'll need to drill holes to mount it. I used m2 hex bolts/nuts.
Short test video (need to work on vibration): https://youtu.be/XDReooNcUJ8
On Car: https://youtu.be/g2WcdrCUELM
| gimbal_stand_lowest.stl | 83.7KB | |
| pan_tilt_base.stl | 73.6KB |
