Here is a spool holder for the Palette 2. It reuses the 10mm rods from the stock spool holder. It requires 16 608 ball bearings.
I've reposted the left and right end caps. A hole on each side will print shallow. If you print the left and right end caps print with the REV_2 parts.
endcap.stl | 61.0KB | |
Endcap_left_narrow.stl | 87.6KB | |
Endcap_left_rev2.stl | 73.8KB | |
Endcap_right_narrow.stl | 87.6KB | |
Endcap_right_rev_2.stl | 73.8KB | |
pin_rev3.stl | 94.4KB | |
Roller_Hold_rev_2.stl | 134.0KB | |
roller_rev_2.stl | 526.4KB |