This is a filament guide for the Palette 2 and Palette 2 Pro.
The input section on those devices have a massive design flaw that will cause the filament to get stuck in a gap under the filament run-out detector switch during a run-out event if it is bent in the right direction.
This will cause a jam during the spool switch over that is supposed to happen when one spool runs out in multi-spool mode.
This essentially render multi-spool mode useless on the Palette 2 (Pro).
The guide is a small cap that snaps over the detector switch and fills that gap and prevents the filament from getting stuck.
This together with the external filament buffer I also have on Thingiverse makes it possible to use this very useful mode of the Palette 2 without an extreme risk of having it ruin your print.
More information about the filament guide here:
https://youtu.be/JUrblIVPj8Y
And more information about the design flaw here:
https://youtu.be/K3c33ElgW68
| Palette2InputGuide.stl | 6.7KB |
