Pacifier REMIX Case Top And Bottom For Mingun Supergun With MD9 Connector. 3D Printer Model
The file 'Pacifier REMIX Case Top And Bottom For Mingun Supergun With MD9 Connector. 3D Printer Model' is (stl) file type, size is 252.2KB.
The file 'Pacifier REMIX Case Top And Bottom For Mingun Supergun With MD9 Connector. 3D Printer Model' is (stl) file type, size is 252.2KB.
I made this remix as I needed a few changes done. For some reason with the bottom base version the hole/slot for the headphone jack was off by 2mm so my board wouldn't fit in.
So I moved this over (towards the jamma) 2mm, and now it fits nicely. I also lowered the floor on the bottom shelf as some of my components legs were bottoming out and they were fairly thick to cut (like the power molex plug ones). I also increased the thickness of the bottom shell since I lowered that floor a bit to compensate and keep structural integrity.
I also added a tiny bit (.20mm) to the lips of the shell so that my jamma connector wouldn't bend when I tightened the screws.
I also had to make the screw holder arms near the jammer connector thicker as I only had 16mm screws that would fit, so its a tiny bit thicker here and you'll need 16mm screws with nuts for the front.
I also moved some of the holes in the top cover around as for some reason these not centered for me and some of the jumpers were harder to move because of it.
Overall this was a much better fit for my minigun.
| Super_Gun_Lower_with_moved_headphone_jack_and_lower_floor_and_20mm_lip_RC2.stl | 705.4KB | |
| Super_Gun_New_Top_v2_no_letters.stl | 180.7KB |
