OZ – Dorothy – 2X 3D Printer Model
The file 'OZ – Dorothy – 2X 3D Printer Model' is (stl) file type, size is 12.7MB.
The file 'OZ – Dorothy – 2X 3D Printer Model' is (stl) file type, size is 12.7MB.
Original Design Wizard of Oz Dorothy - 2X (Double Size)
Everything prints in the orientation of the models.
Might want to use a brim to be safe.
I printed at .12mm using Cura for slicing
For arms start with White filament then switch to Flesh color at layer 113 (Z=13.608)
For dress Start with Red Filament,
Switch to White at layer 52 (Z=6.288),
Switch to Blue at layer 118 (Z=14.208)
Dress is filled in with white acrylic paint, first paint then wipe off blue stripes
Glue on Torso (top of dress)
Depending on how well your printer prints, the head might be a little loose,
If it is, just put a bit of masking tape around the inside of the neck and that should do it.
Also recommend putting a thin strip of masking tape on each of the arms to allow for better posing.
| Dorothy_arm_A.stl | 2.2MB | |
| Dorothy_Dress_Blue_Gingham_B.stl | 17.5MB | |
| Dorothy_Hair_5_Bigger.stl | 3.3MB | |
| Dorothy_Head_2X_T.stl | 4.3MB | |
| Dorothy_Torso_neck_White_4.stl | 3.4MB | |
| Toto_In_Basket_Small_B.stl | 3.5MB |
