Oxberg Knob IKEA Door – 3mm Hole For Screw 3D Printer Model
The file 'Oxberg Knob IKEA Door – 3mm Hole For Screw 3D Printer Model' is (stl) file type, size is 12.5KB.
The file 'Oxberg Knob IKEA Door – 3mm Hole For Screw 3D Printer Model' is (stl) file type, size is 12.5KB.
I needed to make a new knob for my OXBERG doors I'm using on BILLY bookshelves for filament storage. I added magnets to keep the cats out, and it turned out the magnets were so strong that the doors were difficult to open with the stock knobs. I added a flange to make them easier to grip.
When I went to put them on, I found that the 2mm hole was just a bit small for the screws that came with my set, OR the filament I used (Sunlu white) was too firm for the screw to dig into.
This remix is to widen the hole to 3mm in case you need the bigger hole for your screws.
| IKEA-Oxberg-Knob-3mm-Hole.stl | 36.3KB |
