Designed in Onshape.
INTERNAL DIAMETER OF HOLDER =26mm
WIDTH OF BRACKET = 20mm
The bracket is printed assembled on its side.
When printing is complete crack the hinge points by gently opening the bracket.
This bracket is to be mounted using double sided tape.
The hinge will snap close when pushing the mop handle gently into the bracket.
Pull the broom handle gently out of the bracket and the hinge will snap open.
This bracket has not been cycle tested to confirm life cycle.
If it fails dont worry just print another one maybe with a bit more fill. :-)
| Overcenter_Enjo_Bracket.obj | 26.8MB | |
| Overcenter_Enjo_Bracket.stl | 17.1MB |
