Found even more light switches in the house that were too utilitarian and functional. "Nay", said the homeowner. "That shall not do"
I took out a lot of the slop from what's illustrated in the video, shouldn't wobble around as much now.
Only part that needs support is the crank_supports.stl, the rest shall print just fine without any. No additional hardware needed, use your existing wall switch cover.
| crank_supports.stl | 151.7KB | |
| plug.stl | 41.5KB | |
| Rack_Gear_11_teeth.stl | 79.4KB | |
| switch2_v8.f3d | 1.9MB | |
| Switchplate.stl | 72.9KB | |
| wheel.stl | 195.1KB |
