Ortur Complete Upgrades Laser Master Mods 3D Printer Model
The file 'Ortur Complete Upgrades Laser Master Mods 3D Printer Model' is (stl) file type, size is 4.5MB.
The file 'Ortur Complete Upgrades Laser Master Mods 3D Printer Model' is (stl) file type, size is 4.5MB.
Ok. My complete collection of Ortur Laser Master upgrades.
All printed at 0.25 layer height. The legs themself have a tensioner built in to secure the belt and you guessed it, tension it :)
Also a big addition is the fact the legs now encapsulate the 20x40 profile signifacantly.. adjust this is needed to fit your bigger frame."If used with original 20x40" A SIGNIFICANT loss of usable area will occur. This design was to increase frame rigidity.
the air assist standard 5mm fishy wishy tubing stuff..
The Z adjuster is DUAL lockable.. pull back on the handle and it locks into place, then use the screw next to it to completely bind the frame. Happy days
Lots of M3 nuts and bolts are required as its designed with lots of captive bits for strength and rigidity!! GRRRRRRRR. Nothing worse than a stripped thread in plastic!
| Complete_z.stl | 23.1MB | |
| FAN_ASSIST_OTHER_SIDE.stl | 560.7KB | |
| FAN_SCREW.stl | 987.1KB | |
| FIXER.stl | 407.7KB | |
| GEAR_TURNER.stl | 481.8KB | |
| GRIP_LASER_NONE_TOOTHED.stl | 122.9KB | |
| GRIP_LASER_TOOTHED.stl | 396.7KB | |
| LASER_ATTACH.stl | 825.2KB | |
| LEG_CIRCUIT_CIRCUIT.stl | 1.9MB | |
| LEG__BELT_TENSION_ADJUSTER.stl | 1.3MB | |
| MAIN_COMPONENT.stl | 308.9KB | |
| NUT_THUMB_SCREW.stl | 1.0MB | |
| ortur_rear_holder.stl | 100.4KB | |
| PLATE_ORTUR.stl | 381.9KB | |
| SCREW_TURNER.stl | 1.3MB | |
| TOP_HOLDER.stl | 66.5KB |
